2014年11月6日星期四

Super Thin LED Panel Light

Eestablished in 2010 ,ShenZhen Angelila Technology Co.,LTD, is a specialized manufacturer of DIY led grille panel light, ultra slim LED panel light ,LED downlight in China. We produce many types of LED light panels, Some advantages of our LED Panel lights as below:
a. Energy saving around 70%;
b. Long life more than 5 years (about 50000 hours)
c. No infrared rays, no ultraviolet radiation, and low thermal effect;
d. Ultra slim and easy installation;
e. Even, soft and wide light emitting;
f. Special circuit design, avoiding the single broken LED influence problem;
g. High efficiency constant current drive system, with heat protection system;
h. Instant start, no flickering, no humming, no RF interference.
i. Top Performance
LM-80 approved LED.
CRI>80.
<5% brightness decay after 6000hrs.
Super thin.
Side-lit technology.
j. Smoother Area Light
LED panel light generates smoother and more comfortable light than other lighting solutions, which is the trend of future indoor lighting solution.
k.Elegant Look
600*600mm, 300*1200mm, 600*1200mm common models are provided. They are designed to replace the old office fluorescent tube fixture in Australia and USA.
l.Back
LED ceiling panel light can be recessed into the ceiling with 4 clasps, and connected to an LED driver through a lead.
m.Applications
LED ceiling panel light can be used in office building, business center, home, and so on.
We will do our best to satisfy your needs and never let you down!
Related reading: wholesale LED ceiling lights  Panel light suppliers  Recessed LED Ceiling Lights

2014年10月24日星期五

The Development Of LED Illumination Technology

LEDs are arguably the most energy-efficient light source available. Case in point, LEDs have created upwards of 80 percent energy savings in the traffic signal industry. However, in this application, the LEDs had two natural advantages:

1. LED flat grille lights are monochromatic, so almost all of the light generated is used. In contrast, the white light generated by an incandescent bulb needs to transmit through a colored filter. Light outside of the frequency of the colored lens is wasted.

2. LED ceiling lights are directional, so almost all of the light generated was emitted towards the lens. In contrast, light from an incandescent bulb needed to be reflected toward the lens, resulting in loss of efficiency.

Commercial and residential lighting applications stand to gain similar, if not more, energy-savings by converting to LEDs. However, most applications are not as straight-forward as stuffing a PC board with a bunch of directional red, amber or green LEDs. LED light fixtures and retrofit packages have to be designed to distribute the directional light generated by the LED over wide areas. Moreover, white LED technology, while continuously improving, does not yet have the optical color and brightness that consumers have become accustomed to with incandescent lights. However, the power savings can be significant, for example, in California the energy commission has adopted efficiency standards for residential and commercial buildings. These standards, Title 24, have accelerated development of LED illumination technology.

ShenZhen Angelila Technology Co.,LTD, is a specialized manufacturer of DIY LED grille panel light, ultra slim LED panel light ,LED downlight in China . We have been recognized by more and more terminal clients from many countries, such as




2014年8月29日星期五

What should you know when purchasing LED lights bulbs?


The intrinsic characteristics of LED's decision that it is the ideal light source to replace the traditional light source, it has a wide range of uses.   LED light technology with cold, much less heat than conventional lighting.
1. While the initial cost per bulb is still high, the total lifetime cost of an LED light bulbs is actually lower than that of equivalent incandescent and CFL bulbs. Taking into consideration energy costs as well as time and resources required to replace incandescent and CFL bulbs, an LED bulb that lasts 80,000 hours has a much lower lifetime cost.

2. LEDs are diverse, and - as unlucky purchasers are all too likely to find out the hard way - many types are useless for general lighting applications. The finest B22 LED bulbs. By the way, is a quantitative measure of the ability of a light source to reproduce the colors of various objects faithfully in comparison with an ideal or natural light source. LED light bulbs that use top-quality LEDs will last much longer than the novelty bulbs that many are selling and 60% longer than many competing bulbs that use inferior LEDs.

3. Contrary to what you may read some places, LEDs do generate heat, and this heat is actually the biggest problem that manufacturers face developing LED lighting applications. Manufacturers can now produce individual LED chips that are as bright as a 100-watt incandescent bulb, but these LEDs are practically useless for general lighting because installing them in a fixture creates ventilation problems that have not yet been solved. LEDs installed in fixtures and bulbs must be ventilated properly, and the better the chip, the more difficult it is to properly cool. There are many LED light bulbs on the market that do not take this into consideration and either use cheap chips so they don't have to ventilate them, or do not ventilate their chips properly, significantly reducing its lifespan. While the typical LED light bulb is barely warm to the touch, if the chip is not properly ventilated, it can fail prematurely.

4. While LED light bulbs do last much longer than conventional bulbs, look closely at manufacturer claims for bulb life. The life-span of an LED light bulb should be its "half-life." LED light bulbs do not burn out; rather, they gradually fade out. When a vendor says an LED bulb will last 80,000 hours, they mean that at that point, the chips will have reached 50% efficiency, and the bulb ought to be replaced. So, the bulb might last 100,000 hours or more, but its efficiency will have degraded greatly by that point. Using this 100,000-hour life as a selling point is therefore misleading. While LEDs don't last forever, they will last 50-75 times longer than a comparable incandescent and 6-8 times longer than a CFL.
ShenZhen Angelila Technology Co.,Ltd. is LED lights manufacturer ,LED lights driver and led lights control solution provider in Shenzhen . Since Founded in 2010 , we always endeavor to research & development of lighting in LED ,our well trained production and QC staff can assure all the products perfect performance ,and our knowledgeable and informed engineers can satisfy our clients various good ideas and requirements .
Address: No.A building,Hengfu Industrial Zone,ShiYan town,Shenzhen,China
Email:  info@angelila.com
Tel: +86-755-27353568

Fax: +86-755-23093566

2014年8月1日星期五

Led Panel Lighting Solutions And Their Advantages

Led Panel Lighting Solutions And Their Advantages
 LED (light emitting diode) lighting is a form of solid-state lighting is very effective, long-lasting, durable and square LED panel lights use light-emitting diodes as a light emitter these. It does not use gas or filament light bulb glass as incandescent and fluorescent bulbs. The LED lamp has a small or a lens capsule in which the microchip is placed in a heat conductive material, which contributes to energy saving of about one hundred percent, while also providing a long-life of about five years.  This Round Led Panel Lamps from our factory are slim and efficient characteristics
These lights can be easily inserted into a very simple installation process with the help of the ceiling. LED lights effectively applied to hotels, conference rooms, offices, hospitals, schools, commercial complexes, residential / institutional buildings and places that require high color rendering index lighting and energy needs. LED light board has three different categories; i.e., round, square and rectangular. There are also some types of LED panel lights, including construction, when the normal installation method to install, pause, and depression. These lights are bright light is basically beneficial and reduce electricity, upgrading infrastructure and residential or commercial buildings more energy costs borne.
Our Led Flood Light With U.S. Brigelux is a square. Advantages square LED panel: These panels are very useful because they provide a high strength and low power consumption. LED panel is a high-impact, anti-vibration, they have a very long life, about 40,000+ hours. Other benefits is its ability to instantly start, there is no buzz, no RF interference, no buzzing noise, no fluorescent flicker, no hazardous mercury or lead entering the environment, the risk of broken glass, maintenance-free, easy to install, high efficiency constant current drive systems.
Our Led Tubes And Bulbs are good indoor lamps. Its LED colors include colors such as yellow, red, green, and blue. In fact there is no such thing as €€ white LED. To get white light, that our home and office lighting we use is a mixture of different colors or covered with LED light color fluorescent conversion material. The yellow phosphor material, you can look at some of the LED products.

LED lamps offer almost zero light emitting diode illumination few non-ultraviolet and near-infrared emission, and because of this reason UV emission, LED illumination is quite suitable, not only for goods and materials are sensitive to heat, due to the small the benefits of radiant heat, but also for UV-sensitive objects or lighting materials, such as archaeological sites, art galleries, museums and so on.